Dropped the Warp6 off at the shop. My guy had a set of John Kaase Boss 429 heads on one of the benches that will be going on a 570ci+ boss engine.
So we set the Warp6 next to one and did a simple camera compare.
Now that we have heads in hand, One can go to CP so we can get the hard anodized pistons underway and one can go on the bench for some flow testing.
We are removing the seats because they are for Ti valves. I am not using Ti valves. Wanted something modern for seat material. Did some research.
Were using Moldstar90 material. You can use either Steel or Ti valves on this material. My guy will make the new seats out of that. I have the round bar
coming. 12" of 2.500" dia and 12" of 2.00" diameter.