View Single Post
Old 04-25-11, 06:56PM   #4
KINGPIN
Kansas Farm Boy
 
KINGPIN's Avatar
 
Join Date: Mar 2011
Location: KANSAS
Posts: 164
Default

I have been contemplating a 69 gto front bumper from vfn. My references were to the sheet metal hoods, no slight intended to fiberglass. in fact had i known the metal hood for my gto was so flimsly i woulda went with a vfn fiberglass one. I literally dented the hood when i closed it the first time in the same fashion I would close a factory hood. mistake. also the underhood bracing was not attached to the hood hardly at all. the hood flexed up and down bad first time i drove it. if you get a metal hood and it came on the boat be prepared to weld up the bracing. front valance same thing. weld to make right. goodmark hood, didnt havta do a thing.
KINGPIN is offline   Reply With Quote
 
Page generated in 0.04158 seconds with 13 queries